Tablet, Monitor and Phone Mount Instructions

Installation guide for Worm Pop Labs tablet, monitor and phone wall mounts.

What is included

  • Tablet plate, with security tape already applied
  • Wall plate
  • Screws (2x)
  • Command strips
Tablet mount parts laid out: tablet plate with security tape, wall plate, two screws, and command strips
Everything in the box.

Installation

Before step 2

Wait one full hour after applying the command strips. This is what gives you maximum adhesion, and it is the step people skip. A mount that falls off a week later is almost always this step.

  1. Prepare the tablet plate. Apply the two included command strips to the designated areas on the back of the tablet plate.
    Command strips applied to the back of the tablet plate, with the wall plate and a screw beside it
    Command strips go on the marked areas of the back plate.
  2. Attach the plate to the tablet. Peel the red backing from the security tape and the paper backings from the command strips. Align the tablet plate with the top portion of the back of your tablet, positioning it as close to the top edge as possible, then press firmly to secure it.
    Tablet plate pressed onto the top portion of the back of a tablet
    Position as close to the top edge of the tablet as you can.
  3. Mount the wall plate. Pick your location, then mount the wall plate with the provided screws. Check that it is level before you tighten down — the tablet will show any tilt.
    Wall plate screwed level to a wall
    Wall plate fixed and level.
  4. Mount the tablet. With the wall plate secure, slide the tablet onto it. That is the finished install.
    Tablet mounted on the wall plate, sitting flush against the wall
    Finished install.

Related guides

Something not right?

Missing a part, or the mount does not fit your tablet — send us a message. We answer every one.